fits  03-22 Touring; 02-17 (NU) V-Rod

Used to remove the electrical connector without damage to the ignition switch.

Δείτε περισσότερα στον κατάλογο

Home > Workshop > VTwin Tools > Electrical > MCS, ignition switch remover tool

fits  06-17 Dyna (NU)

Used to remove and install both the fork lock/ignition switch combo with ease. Installs on the ignition switch. Comes with 3/8″ drive.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > MCS, Dyna ignition switch & fork lock tool

fits  03-13 Touring; 02-17 V-Rod (NU)

Used to correctly align ignition switch housing for installation.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > MCS, ignition switch housing alignment tool

fits  18-22 Softail; 17-22 Touring

Pulls and installs alternator rotor as used on M8 motors. Overcomes the strong pull of the high performance rare earth magnets that are used with ease. Prevents damage by using inappropriate tools as hammers or pry bars.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > JIMS, alternator rotor tool

fits  95-06 (NU) FLT; 01-06 (NU) Softail; Custom applications

Pulls 29981-95 (38A) & 29999-97A/B (45A) style, and similar, rotors with a threaded pull action from the sprocket shaft. Especially helpful with the strong magnetic hold on 45 Amp charging systems.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > JIMS, alternator rotor puller tool

fits  H-D models with alternator rotors with 2 holes

Used for easy removal of the alternator rotor from the strong magnetic hold of 45 Amp charging systems. Will fit most rotors with a two hole system. Simply insert, pinch and pull tool to remove rotor.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > Evolution Industries, alternator rotor puller

fits  03-13 Touring; 02-17 V-Rod (NU)

Used to correctly align ignition switch housing for installation.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > George’s Garage, ignition switch housing tool

fits  03-23 Touring; 02-17 (NU) V-Rod

Used to remove the electrical connector without damage to the ignition switch.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > George’s Garage, ignition switch connector tool

fits  14-22 Touring

Used to align the ignition switch housing when retaining screws are torqued. Correct alignment for the ignition switch knob is required to help prevent premature failure.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > JIMS, ignition switch alignment tool

fits  10-20 Touring (NU)

Used to install & remove 12mm threaded 4-wire heated front & rear oxygen sensors. Can be used with a torque wrench for a factory spec installation.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Electrical > JIMS, O2 sensor wrench tool