fits  58-99 Big Twin (Excl. Twin Cam) (NU)

For 9058 cam bearing in crankcase. Dual end gauge pin, one side is a Go other side is No-Go gauge. Used to check if the tolerance of the bushing/bearing is within spec, or that a replacement is in order. For a quality job without guesswork.

Δείτε περισσότερα στον κατάλογο

Home > Workshop > VTwin Tools > Engine Lower End > Fast Eddy, cam bearing Go & No-Go gauge pin

fits  58-99 Big Twin (Excl. Twin Cam) (NU)

Used to remove the pinion bearing race / pinion shaft bushing (24599-58A/B, 24599-93) from the right side crankcase. Replacement for OEM 39958 tool.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > General Tools > Specific Tools > MCS, pinion bearing race removal tool

fits  58-99 Big Twin (Excl. Twin Cam) (NU)

Used to check the inner size of the cam needle bearing. With not enough press-fit the cam can rock, causing noise and unnecessary cam/bearing and roller wear. Too tight bearing can damage cam and cam bearing. Sold in set of 2 (one go & one no-go pin). Quick & easy to use.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Engine Lower End > JIMS, inner cam bearing gauge pins (pr)

fits  58-99 Big Twin (Excl. Twin Cam) (NU)

Used to press the inner cam needle bearing smoothly and easily into the right crankcase half, with cases assembled, to the correct depth. Note: Use JIMS tool MCS 978288 to remove bearing.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Engine Lower End > JIMS, cam bearing installer tool

fits  99-06 Twin Cam (Excl. 2006 Dyna) (NU)

Once the camshafts are removed from the support plate, this tool will remove the bearing from the camshaft. Unlike a general purpose puller this tool was designed to remove the bearing straight with no slipping or binding.

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Engine Top End > JIMS, cam bearing remover tool

fits  58-99 Big Twin (Excl. Twin Cam) (NU)

Used to remove the needle bearing from crankcase with a controlled press-out action; Case disassembly is not required Note: See 979405 for press-in installer tool

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Engine Top End > George’s Garage, cam bearing remover tool

fits  58-99 Big Twin (NU) (Excl. Twin Cam)

Used to install the needle bearing from crankcase with a controlled press-in action; Case disassembly is not required Note: See 979404 for remover tool

Δείτε περισσότερα στον κατάλογο Workshop

Home > Workshop > VTwin Tools > Engine Top End > George’s Garage, cam bearing installer tool