fits 

9-step 12V / 12.8V 1.25A sealed battery saving charger & maintainer for AGM, GEL & STD 12V and works with 12.8V Li-Ion made batteries with LiFe & LFP technology. Note: Quad program – select program 1 or 3 to charge battery direct or through a live (hot) 12V socket, or program 2 or 4 to charge through BMW CAN-bus controlled 12V socket. Will require optional cable accessory to connect to socket. – Fully automatic and safe charger / trickle charger for 24-7 use – BMW CAN-bus compatible, automatic activation – Smart desulphation from 0.5V, for Pb (conventional lead acid) batteries – Low voltage recovery & BMS reset, for LFP battery – Tests battery state of health – Energy saving technology – Stand-by power less than 0.5W – Efficient 24-7 battery maintenance – Weatherproof – Rated for use down to -40°C / -40°F – No risk of overcharging – Sparks suppressed – Safe for vehicle electronics – Safe for long-term battery maintenance – Automatic shut-down if short-circuited or battery disconnected – Includes weatherproof battery lead, battery clip set & hanging hook.

Δείτε περισσότερα στον κατάλογο

Home > Workshop > Battery Chargers > Tecmate, OptiMate 4 Quad Program

fits  Universal

Bronze. 5-step 12V / 12.8V 2A sealed battery maintainer. For Lead Acid, AGM, GEL 12V batteries from 6 to 96Ah and 12.8/13.2V lithium (LiFePO4) batteries. It senses the battery condition, recharges and then keeps the battery 100% ready. The fully automatic maintenance program provides what the battery needs, never overcharges, never undercharges. – Charging Amps: 2A (constant current) – Charging volts: nominal: 12V & 12.8V range: 4V – 14.4V – Indoor / Outdoor (lowest temperature: -40°F / -20°C) – For Lead Acid, AGM & GEL 12V batteries from 3 – 96Ah – Input: Global (100-240V 50-60Hz), high efficiency (CEC listed), fully sealed – Weatherproof case with wall mounts – Incl. 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector – weatherproof battery lead & battery clip set – No risk of overcharging – Sparks suppressed – Safe for vehicle electronics – Safe for long-term 24-7 battery maintenance – Automatic shut-down if short-circuited or battery disconnected

Δείτε περισσότερα στον κατάλογο

Home > Workshop > Battery Chargers > Tecmate, Optimate, 2 Duo 12V battery charger. Bronze

fits  Universal

9 step 12V / 12.8V 1.25A sealed battery saving charger & maintainer for AGM, GEL & STD 12V batteries from 4 – 60Ah & Lithium (LiFePO4) 12.8/13.2V batteries from 2 – 15Ah. OptiMate 4 Quad Program tests before & after charging and can recover a ‘dead-flat’ lead-acid & lithium (LiFePO4) battery from as low as 0.5 Volts. – Selectable, 4 charge programs: 1).12V Smart desulphation: 0.5V – 14.4V. 2). BMW CAN-bus compatible: 5V – 14.4V. 3). 12.8V Low Volt Recovery: 0.5V – 14.4V. 4). BMW CAN-bus compatible: 8.8V – 14.4V. – Charging Amps: 1.25A (constant current) – Indoor / Outdoor (lowest temperature: -40°F / -40°C) – Save: Low Volt Start of 0.5V + 2-step* desulphation recovery (*1-step low volt pulse save during CAN-bus mode) – For 4 x Lead Acid, AGM & GEL 12V batteries from 3 to 50Ah – Input: Global (100-240V 50-60Hz), high efficiency (CEC listed) – Weatherproof case with wall mounts – Incl. 6ft. / 180cm AC supply lead and 6ft. / 180cm charge lead ending in SAE connector. Weatherproof battery lead, battery clip set & hanging hook – No risk of overcharging – Sparks suppressed – Safe for vehicle electronics – Safe for long-term battery maintenance – Automatic shut-down if short-circuited or battery disconnected.

Δείτε περισσότερα στον κατάλογο

Home > Workshop > Battery Chargers > Tecmate, OptiMATE 4 Quad Program 12V battery charger

fits  Universal

With EU wall plug. Professional variable 0.4A to 10A 12V diagnostic battery charger-tester & power supply for powersport & small craft / machine professionals, repair shops and battery retailers. – Pro use: 12V lead-acid STD & AGM from 3-50Ah and 12.8V/13.2V Lithium LFP (LiFePO4) from 2-20Ah. – Normal use: 12V lead-acid STD & AGM from 3-240Ah and 12.8V/13.2V Lithium LFP (LiFePO4) from 2-120Ah. – Charging Amps: 0.4A to 10A variable (Ampmatic) – Charging Volts: 12V lead-acid: 0.5V to 22V. 12.8V/13.2V Lithium LFP (LiFePO4): 0.5V to 14.4V. Powersupply: 11V to 13.6V. – Operation: selectable – 11 step charger – 3 Selections: Select a charge mode for 12V lead-acid OR 12.8V LiFePO4, or select PowerSupply mode for battery support during vehicle diagnostics, tuning or troubleshooting – Automatic fast battery activation: flashing green test light indicates battery is healthy and sufficiently charged – Smart recovery mode for deep discharged batteries, a bad battery is quickly identified, a good battery receives charge is retested after – Pushbutton activated BMS reset for LiFePO4 batteries – Test indication for GOOD (80 to 100%), OK (60 to 80%) and BAD (below 60%) batteries – Powersupply mode provides constant power for vehicle tuning, diagnostics and troubleshooting – Case with rubber bumbers, with wall-mount or hanger bars. AC Class 2 input socket, with ON/OFF switch, 15cm / 6″ output cord – Certification – CE, UKCA, NRTL (UL & CSA), PSE (Japan), SAA (Aus & NZ) – Indoor use. IP40 rating – Included cables: Class II AC cord suitable for region, O-43 charge lead extender 180cm/72″ and O-14 fused battery clips – Vehicle hanging hook and wall receiver included

Δείτε περισσότερα στον κατάλογο V-Twin

Home > Workshop > Battery Chargers > Tecmate OptiMATE, Pro 1 DUO 12B 10A battery charger

fits 

Monitor cable for Lithium batteries. 60cm long. With M6 / 1/4″ ringlets to 2-pin SAE connector with waterproof sealing cap. – Micro processor driven 4 LED system used to monitor battery status. – Informs you if the battery is in a good/needs charge/not good condition – When the engine is running it also informs you if the vehicle’s charging system is working. Then the LED mode changes to an arrow, with the pointer reaching the LED matching the voltage being delivered by charging system. No arrow means there is no charge – A bright red LED warns that the charge level has reached 50% and that it is time to recharge that battery – During vehicle storage the LED matching the battery’s state of charge will blink every 5 seconds, drawing very little power (0.2 milli-amps) to do so, in fact 20-100 times less than the vehicle’s circuitry is drawing from the battery at the same time – Fast blink mode for first 15 seconds after connection to battery, for quick check of multiple batteries (e.g. vehicles on showroom floor)

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Parts > Electrical > Batteries > Battery Chargers Accessories > Tecmate OptiMATE Monitor O-127 cable. Lithium

fits  Universal

With EU wall plug. Professional 8-bank battery saving charger for power sport & small engine 12V & 6V batteries, including neglected sulphated / low-voltage batteries. Once voltage selection has been made, no further battery knowledge required. Connect up to 8 x 6V and 12V batteries and let the charger do the rest. – The OEM recommended 8-bank battery care center for recovery, charging and testing of all 6V and 12V batteries, including neglected sulphated / low-voltage batteries – 8-bank charger, each bank operates independently – Select battery voltage of 6V or 12V for each bank – 1Ah charging Amps per bank – Use: Indoor / workshop environment (lowest temperature: -4°F / -20°C) – Save: Low Volt Start of 1.8V + 2 step desulphation recovery – For Lead Acid, AGM & GEL 12V batteries from 2Ah – Selectable 110-120V / 220-240V 50-60Hz – On/Off power switch and replaceable fuse protection – Vented industrial table top case. – Incl. 6ft / 180cm AC supply lead and 8 x 6ft / 180cm charge lead ending in SAE connector. 8 x standard battery clip – No risk of overcharging – Sparks suppressed – Safe for long-term battery maintenance – Automatic shut-down if short-circuited or battery disconnected – Use: Indoor / workshop environment (lowest temperature: -4°F / -20°C)

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Workshop > Battery Chargers > Tecmate OptiMATE, Pro 8 battery charger. 12V/6V

fits  Universal

‘State of Charge’ battery tester. For all 12V lead-acid & 12.8V/13.2V lithium batteries. Used to quickly see the battery’s charge condition before a battery is sold, or when it is returned. – State of charge result in Volts and %, 3 different bands for Lead Acid, AGM/GEL and LiFePO4 4 series batteries – Easy to follow instructions on rear panel of the tester – Easily connects with connect clips to the battery or to an installed SAE 2-pin battery lead. – Industry standard SAE 2-pin connector – 100cm battery clip set – Flashing indicator for discharged battery

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Workshop > General Tools > Electrical > Battery Testers > Tecmate OptiMATE, Test TS126 battery tester

fits  Universal

‘Cranking & Alternator’ tester. 12V professional pocket tester for on-vehicle battery cranking performance & alternator charge voltage testing. – Checks battery charge level – Start engine. OptiMate TEST records and indicates (for 20 sec) the lowest start volts – With engine running, verify charging voltage from alternator and voltage regulator. – Microprocessor accuracy – Easy to follow instructions on rear panel of the tester – Easily connects with connect clips to the battery or to an installed SAE 2-pin battery lead. – Industry standard SAE 2-pin connector – 100cm battery clip set – Fully sealed

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Workshop > General Tools > Electrical > Battery Testers > Tecmate OptiMATE, Test TS120 battery tester

fits  Universal

The TestMate provides within seconds a professional assessment of the state of health, state of charge and CCA capability of a 12V battery. The TestMate is compact, light, and can be used in the workshop or at the sales counter. – Professional affordable 12V battery tester – Up to 200 Ah batteries – Select battery type and Ah / CCA, then TEST – For all battery technologies (Lead Acid, AGM, GEL) – Result available in seconds – Rugged, ideal for workshop use

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Workshop > General Tools > Electrical > Battery Testers > Tecmate Testmate Auto 2 battery tester

fits  Universal

Monitor cable for AGM / Lead Acid batteries. 60cm long. With M6 / 1/4″ ringlets to 2-pin SAE connector with waterproof sealing cap. 4 LEDs cover ‘full to empty’ voltage range of all 12V batteries, including higher voltage AGM for power sport (4th √√ LED ≥ 12.7V. – Micro processor driven 4 LED system used to monitor battery status. – Informs you if the battery is in a good/needs charge/not good condition – When the engine is running it also informs you if the vehicle’s charging system is working. Then the LED mode changes to an arrow, with the pointer reaching the LED matching the voltage being delivered by charging system. No arrow means there is no charge – A bright red LED warns that the charge level has reached 50% and that it is time to recharge that battery – During vehicle storage the LED matching the battery’s state of charge will blink every 5 seconds, drawing very little power (0.2 milli-amps) to do so, in fact 20-100 times less than the vehicle’s circuitry is drawing from the battery at the same time – Fast blink mode for first 15 seconds after connection to battery, for quick check of multiple batteries (e.g. vehicles on showroom floor)

Δείτε περισσότερα στον κατάλογο V-Twin; Workshop; Street

Home > Parts > Electrical > Batteries > Battery Chargers Accessories > Tecmate OptiMATE Monitor O-124 cable